Wednesday, February 3, 2010

New axle plates and tail section for a customer.

This guys frame was c-r-a-z-y sketchy!!!
Another drop seat, less than 2" of ground clearance and everything was crooked, porous welds, pipe for tubing...etc.
 We jigged it up on the fab table, fixed up the neck area, straightened it out, got rid of the drop seat crap, Fabbed up a new tail section with .120 wall DOM and installed some new water jet cut axle plates courtesy of Baas metal craft.
We also installed that cheap dna springer as well and made him a headlight, tank and fender mount bungs.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.